News — boot camp

New Boot Camp! In this episode Major Kevin explains how to put together a Hidden Internal Compression System. Featuring all Phoenix Pro Scooters Parts!

This week on Boot Camp, Major Kevin shows you how to install a standard compression system (SCS) on a Phoenix Pro Scooter Deck. The hardest part when installing a SCS is stretching the clamp (only if needed), other than that they are easy to install and Major Kevin takes you through each step.

This week on Boot Camp, Major Kevin shows you how to stretch your pro scooter clamp. Installing your clamp can be difficult if the clamp is too tight to fit over the fork tube or if the bars are not able to slide into the clamp. Clamp stretching is a technique commonly used on standard compression systems, but may also be required on other pro scooter compression systems.

This week on Boot Camp, Major Kevin shows you how to install an inverted compression system (ICS) on a Grit Elit. There are two kinds of inverted compression systems out there, ones that use a shorter bolt, and ones that use a very long bolt. District pro scooters use the ICS system with the shorter bolt, while Grit uses the ICS system with the long bolt. Major Kevin also shows you how to install a star nut into your bars!

This week on Boot Camp, Major Kevin teaches you how to install a threaded compression system on you pro scooter. The scooter used to demonstrate the install is the Grit Extermist. A threaded compression system is the most basic compression system to install and the only tools required would be a large adjustable wrench or channel locks.